Tablesaw Rabbet Dado Jig
Tablesaw rabbet dado jig is bookmark about Accessories bookmarked by kirk with ID 1799538533 was uploaded on 27-02-2019 and has been viewed 318,454 times.
Because the plywood end panels I make for kitchen cabinet jobs are usually worked the same way each time, I found myself setting the rip fence to the same measurements for dadoes and rabbets time and time again.
The simple fixture above solved this problem because it is essentially a pre-measured rip fence that I can use instantly by just popping it into the miter-gauge slot.It's a dual-purpose fixture I just lift it out of the slot, turn it end-for-end and push it back down into the slot to use the other side.
One side cuts dadoes 2 in.from the edge of the workpiece, the other side cuts 3/4-in.rabbets...