Two Router Table Tablesaw Extensions
Two router table tablesaw extensions is bookmark about Accessories bookmarked by joshua with ID 1934235842 was uploaded on 11-01-2019 and has been viewed 277,139 times.
My shop is too small to endure much more big equipment.So when I needed both a router table and additional outfeed support on my table saw, I combined both functions in the extension table shown in the sketch above.
Since the table is bolted to the saw, alignment between extension and saw table is better and the table is easy to clean under.I made the 3/4-in.flakeboard table 32 in.wide.Added to the saw table, this gives 44 in.
of support.Leave a gap between the saw table and extension so that a plywood panel can be ripped, then crosscut with a saber saw or circular saw without moving the panel off the table.The blade will travel between saw table and extension.
Bevel the front edge of the table so it won't catch work as it leaves the saw table.Cut a 10-in.square hole in…...