Shop Made Jig For Trimming Laminate
Shop made jig for trimming laminate is article about Shop Blog bookmarked by nicholas with ID 11249746642 was uploaded on 16-04-2019 and has been viewed 364,319 times.
When applying laminate on a narrow edge, it's a little tricky to not tip the router and undercut the edge while trimming laminate.The surface on which the router must balance is often not wide enough to provide adequate support.
I made this fixture from two pieces of plywood dadoed and scr*w*d together for strength.It makes the job of holding the router at the correct angle for trimming laminate a lot easier and negates the usual balancing act.
Dan Martin, Galena, Ohio...