Multipurpose Sled For The Tablesaw
Multipurpose sled for the tablesaw is post about Machinery bookmarked by wade with ID 12529807199 was uploaded on 08-04-2019 and has been viewed 260,700 times.
I created this jig to straighten curved boards and to cut tapers, and I've found it to be one of the handiest jigs in my shop.Cut the base to size and mount a wedge on one end to create a jam clamp.Then scr*w a hold-down that can be adjusted with a wedge to the middle of the board.
The wedge and hold-down can be relocated as needed.To straighten a curved board, push one end of the board under the jam clamp until it is tight, and swing the other end out until 1 in.or so extends over the edge of the jig.
Lock the board in place by positioning the wedge under the hold-down at the same height as the workpiece, and tighten the hold-down with a screwdriver.Then set the rip fence, and push through to straighten the edge...