Router Table Fence For Edging Discs
Router table fence for edging discs is post about Shaping bookmarked by karl with ID 12735035928 was uploaded on 20-02-2019 and has been viewed 391,552 times.
I developed the fence shown above to shape the edges of round rings, such as clock bezels, on the router table.The fence can shape both outside and inside edges of circular blanks.When shaping the outside edge, some part of the profile must remain uncut to provide a bearing surface against the fence, otherwise the disc would just keep spiraling smaller.
The fence is made by laminating 2-in.wide, 1/2-in.thick plywood strips into two arms that fit together in a finger joint that pivots on a 1/4-in.bolt.The other ends of the fence arms fasten to the router table with wing nuts.
Slots in both sides of the router-table top and in one arm of the fence allow adjustment for different size circles and different width rings...