Boring Cribbage Board Holes Revisited
Boring cribbage board holes revisited is bookmark about Uncategorized bookmarked by mario with ID 1515944857 was uploaded on 02-04-2019 and has been viewed 145,131 times.
Here's a cribbage-board drilling method that's more straightforward than the one offered by Charles Whitney in Fine Woodworking #92, p.20.Start with a piece of 1/8-in.-thick flat iron long enough and wide enough to accommodate three rows of holes.
Using a scratch awl, lay out lines on the iron that correspond to the locations of two rows of holes plus two registration holes, as shown above.Carefully center punch each line intersection.Drill the holes with a drill press and a thick-shank bit specially designed for drilling small holes (about 7/64 in.
) in iron.Regular twist-drill bits have a tendency to bend out of line...