Router Jig For Fluted Posts And Trim
Router jig for fluted posts and trim is bookmark about Woodworking Jigs bookmarked by jimmie with ID 1198764317 was uploaded on 02-01-2019 and has been viewed 77,028 times.
With this simple jig, you can make a fluted post or pilaster door trim in any size or dimensions.Start with a piece of 1⁄2-in.-thick Baltic-birch plywood as wide as the base of your router and at least 18 in.
long, to handle a workpiece 6 in.wide or less.Remove the baseplate from your router and, using the mounting scr*w holes as a guide, drill mounting holes in the plywood base.Now use a bandsaw or router to cut two slots in each end of the base, right up to the edge of the router location.
Finally, drill a center hole in the base for the router bit...