Pin Router Attachment
Pin router attachment is bookmark about Woodworking Jigs bookmarked by leroy with ID 1165470703 was uploaded on 02-04-2019 and has been viewed 348,403 times.
By bolting a simple router arm and an auxiliary table to my drill press, I can convert it to a pin router.This lets me take advantage of the drill press' quill movement to lower the router into the work.
Make the router arm from a 20-in.length of 2×6 lumber.Drill the arm to fit your drill-press quill and feed stop, then notch the back of the arm so it can slide up and down the post.On my drill press the arm is held in place well enough by the drill-press feed-stop collar and the feed stop.
Other drill presses might require bolting the arm directly to the housing.In the end of the arm, cut a hole the same size as your router.Then cut a slot in the arm and install a bolt to pinch the router and lock it in place...