Build A Cozy Bird Cabin
Build a cozy bird cabin is bookmark about Woodworking bookmarked by phillip with ID 11665437475 was uploaded on 09-01-2019 and has been viewed 264,719 times.
Build a Cozy Bird CabinPretend you're a chickadee or a white-breasted nuthatch (or even a humble house sparrow), flapping your little wings through the trees in search of food.Which is more appealing: a hurried bite at one of those bland industrial plastic tubes, or a relaxed meal with friends at an inviting thatch-roofed cabin?Here's How to Build This Charming Bird Feeder:1.
Build the Base StructureCut the sides of the feeder from a 2x4 and the roof, top brace and feeder tray from a 1x6.Attach with 2-1/2-in.rust-resistant screws and exterior glue.Don't attach the roof to the sides—it slides up hanger wire so seeds can be poured into the bin from the top.
2.Attach the Branch TrimRip a 1-1/2- to 2-1/2-in.branch in half with a jigsaw, miter the ends, then attach to the roof edges with 2-1/2-in.screws.Pre-drill all scr*w holes, and don't worry if the cuts are rough and uneven—they're supposed to be.
2a.Attach Branches as TrimThe branches should be more or less flush with the bottom edge of the roof boards.3.Gather and Arrange the Thatch RoofTape the thatch from brooms to hold it together, then cut it 7-1/2 inches long with a sharp knife.
3a.Attach Twigs to RoofArrange the thatch on the roof and nail two green twigs to each side to hold it in place.The feeder makes a convenient brace.Trim ragged edges with scissors after the thatch is nailed down.
4.Attach the Acrylic Sheet and FinishDrill three scr*w holes slightly bigger (5/32 in.or more) than the scr*w size through each side of the acrylic.Attach each piece of acrylic with six pan-head screws, but don't over tighten, or it might crack.
Leave a 1/2-in.gap at the bottom for the bird feed to flow out.Screw or nail on half branches around the perimeter of the feeder tray to keep the feed in place.Finally, drill a hole at the center of the roof and the top brace, and slip wire or rope through for the hanger.
Plus, Check out how to miter on tree branches!Project PDFs:Click the links below to download the cutting list, shopping list as well as the construction drawings for this project.Figure ACutting ListShopping List...