Ikea Kallax Hack Craft Room Storage
Ikea kallax hack craft room storage is article about Woodworking Projects bookmarked by jay with ID 11185632825 was uploaded on 11-03-2019 and has been viewed 416,895 times.
Basic Kallax UnitBuild this craft room storage table with just three Ikea Kallax shelves and other basic materials.Plus: Check out these other incredible Ikea hacks you can DIY.Make the Top and BaseCut hardwood plywood for the top and base and install hardwood edging and iron-on edge banding.
Fasten Units to BasePosition two Kallax shelving units back to back and fasten them to the base with flat-head sheet metal screws after drilling countersink pilot holes through the Kallax frames.The frames are hollow panels, so be careful not to punch through their thin faces when drilling the countersinks.
Make sure the scr*w heads sit flush.Fasten TopInstall the third Kallax unit across the front of the base, using the same method.Then tip the assembly over onto the top and fasten it as before.Attach CastersInstall locking swivel casters.
Round Edges and Install DrawersTip the assembly right-side up and round over all the top's sharp edges with a router and a round-over bit.Complete the job by installing Kallax drawer inserts and applying your favorite finish to the top.
Additional Project InformationThere's no shortage of creativity when it comes to new ways to use IKEA products.Here are 12 fantastic IKEA hacks...