Diy Pour Over Coffee Maker
Diy pour over coffee maker is post about Woodworking bookmarked by francisco with ID 1335401015 was uploaded on 14-01-2019 and has been viewed 413,890 times.
Materials & Tools1x6 walnut board (approximately 3 ft.)Funnel1/4 x 2-in.hanger bolt (2)1/4 x 1/2-in.well nut (2)1/4-in.flange nut (2)1/4-in.hex nut1/2-in.Forstner bit2-1/2-in.hole sawWood scr*w (2)Miter sawDrill/driverNut driver or wrenchCutting board oilCabinet hardware (optional)Prep the Wood PiecesCut three pieces from the 1x6 walnut board: one 11-1/2-in.
back piece, one 8-in.bottom piece and one 6-in.top piece.Lightly sand any rough edges.Use a hole saw to cut a 2-1/2-in.hole in the top piece for the funnel.Be sure to center the hole between the sides and leave at least 1-1/2 in.
of wood at the back for the hanger bolts.To avoid tearout, cut until the bit goes through the wood and then flip the piece over to finish cutting out the hole.Drill pilot holes for the hanger bolts in the back edge of the top piece, 1 in.
from each side.(A drill press is very useful for making these pilot holes perfectly straight.)To scr*w in the hanger bolts, create a head by threading a hex nut and fl*ng* nut onto the bolt side.Lock the two nuts together tightly.
Then use a nut driver or wrench to turn the head and scr*w the hanger bolts into the pilot holes.Use a 1/2-in.Forstner bit to drill four holes in the back piece to make the coffee maker adjustable for standard and travel-size mugs.
Mark the top set of holes 1 in.from the sides and 2 in.from the top.Mark the second set of holes 1 in.from the sides and 4 in.from the top.Drill pilot holes for the cabinet hardware, if you chose to include a handle for storing filters, as shown.
Assemble the Coffee MakerClamp together the bottom and back pieces and drill pilot holes for the wood screws.I used a countersink bit, so the scr*w heads will be flush with the wood.Lightly sand any rough areas on all wood pieces with fine-grit sandpaper; wipe off the dust.
Use a clean cloth to apply a generous amount of butcher block oil or other food-safe finish, remember to get inside the holes, and then wait at least 20 minutes before wiping off any excess.Screw together the bottom and back pieces with wood screws.
Add the cabinet hardware to the back piece.On the top piece, thread the well nuts onto the hanger bolts.Insert the bolts into the top or bottom set of holes in the back piece; then add fl*ng* nuts to the bolts at the back of the coffee maker to hold the top piece in place.
Finally, place the funnel in the hole in the top piece and get brewing!Click here to see our Top 10 Woodworking Projects.Click here for 14 Gifts You Can Make in a Weekend...