Saturday Morning Workshop How To Build Speaker Stands
Saturday morning workshop how to build speaker stands is article about Woodworking bookmarked by kirk with ID 11479778139 was uploaded on 17-01-2019 and has been viewed 421,928 times.
Cutting List (One Stand) Tech Art Glue Up Boards We wanted to spice up this build a bit, so we decided to incorporate a light-dark contrast with the legs.Glue up the boards face-to-face, making sure that the glue is spread all the way to the edges.
Clamp, let dry, and sand the edges so that the boards are flush.Cut Plywood to Size Cut two pieces from the 3/4-in.plywood to the size of your speakers.Ours are 11 in.x 13 in.Find Angle for Legs Use the scrap piece of plywood to map out the angle for the speaker stand legs.
Decide the height you want for the base of the speakers, and make a mark on the plywood (32 in.for us).Mark the depth of the speaker (13 in.).Lay the 1x4 board assembly on the plywood, lining it up with both the corner of the plywood and the 13 in.
mark from the edge.Scribe along the 1x4 board assembly, take the assembly away, and find your angle with a protractor or speed square (17 degrees for us).Cut that angle onto one end of the 1x4 board assembly.
Cut the Second Angle To mark your cut for the bottom angle on the speaker stand legs, lay the board assembly on the plywood template again, and use the plywood edge to scribe the non-angled end of the board assembly.
Be sure to consider which wood species (light or dark) you want on the inside and outside of your finished speaker stand legs, and keep that in mind when making your angle cuts.Fasten Legs to the Top and Bottom Use a No.
8 countersink bit and 2-in.No.8 construction screws to fasten the legs to the base.We sketched out the hole locations for all of the parts to ensure that the pilot holes match up.Edge Band the Plywood Rough cut the banding veneer to the length of the plywood edges for easier application.
Empty the water out of the iron and heat it up.Press firmly on the banding with the iron, moving along the edge to activate the adhesive backing.Make sure to keep the iron moving, so you don't scorch the wood.
Add wood finish and paint, if you wish.Click here for more information about iron-on edge banding...